The Radio Information Board

Hello The old 1000 repeater had the basic controller with the cards to give the owner some options CW IDer, 4 CG tones and Tone control If you wanted any other options like DPL, Phone interconnect or air time billing you would remove the controller and replace it wit a Zetron, CTI, CES or some other...

Hello
Anyone know where or have a Service manual for CM-4010A
Small town, Small street Dept., Small budget and I left trying to fix it
Tom

The cable between the control box and radio is a 8 connector,
a cat 5 plug will work if you file the sides down.
The 3 connector jack is for Ingition sense.
I'll look to see if I have a extra manual
Tom

Ok we will start with Volume = speaker level Channel/System = the tens spot in the channel selector or System number in a LTR system Channel/Group = the ones spot in the channels selector or Group number in a LTR system (Nice channel selector can move up/down by ten ex. 1 to 10 or 20 ...) Scan = tur...

Hi
not a bad radio
7167 is a dash mount, 7167-5 remote mount,
computer program.
I have 2 and 1 45 watt version.
What do you want to know?
Tom

Morning This is a call for help on the Prom Programer II used on the SDL, LTR and other radios builded back in the 80's. Local Ham club would like to do a cross link from 440 to 2 meter. They have a SDL 6055, I have a Prom Programer II and a spare Prom What I need is the numbers to put into the prom...

Hi Working on a EFJ 7162 that the channel and option buttons will not work.
You take the case off and use a metal screw driver and all 4 buttons work.
The rubber pad has gone bad?????????????????????????
I tried to clean it with no luck
Anyone have seen this before and what is the fix???
Thanks
Tom

Hello
If you do fined some I could use one also
tom

Hello Its more then getting the wires to the correst pins I open my cable up to see way they used a 25 pin connnector I was going to change it over to a 9 pin one There is one big IC inside and 2 smaller chips If you want I can draw out the wires to pins but on the chips not sure where you would go ...

Hello
Back in the late 80's I was working at EF Johnson in Waseca MN.
The design group on the challenger mobile radio where working on 2 control heads on the remote mount radio's.
I have a 7165-5 mobile and would like to have have 2 control heads.
Does anyone know if this was an option?
Thanks