The Radio Information Board

Trying to load the 32ch codeplug. Also checked to make sure the 8 pin EEPROM chip was in place and matched the chip in the head. The 24 pin EEPROM is an FAA so it is a single band setup. Also, while looking at a different 730 I realized that there is a white plug with a black jumper wire attached on...

Sorry I forgot to include this part......I can get it into programming mode but everytime it tries to program it either shows error on the screen or it says end then after powering the radio back on, all that is on the screen is a bunch of junk. Thanks for the replies so far.

Hey guys, Having some difficulty programming my buddies radio. He picked it up on Ebay from a city govt. that had upgraded to 800mhz. I tried repeatedly to read or write the radio and all I am getting is error messages. Except for one time the display flashed "head 2" while it was trying t...

Hi Everyone,

I was wondering if anyone knows how to adjust the RF Power Output on the Kenwood TK-730G series radio?

Thanks In Advance,

Mike

And to add to the above question, how can you tell if it is already installed, how hard is it to get one if it's not, how difficult is it to install and does anyone have a copy of the service manual to make my life easier. I think I am done now.

Mike

Hi Everyone,

I have a 730(G) series radio and I have been hearing about an option on the radio called PPM 2.0 . Is there anyone out there that can tell me what this is and how do I know if it is installed or not.

Thanks,

Mike

Hi Everyone,

Just wondering if anyone out there knows where I can get an instruction manual and/or programming manual for the Kenwood TK-730G series radio.

Thanks