The Radio Information Board

Does anyone know the part number for a tk-790 service manual?
Thanks Jeff

Does anyone now how to enable field programming on a tk-270 DTMF?

Thanks

What do I need to do if anything to change from a full feature head to one with the speaker in it?

I have all the stuff to do the programming on the Kenwood radios and have for the last couple of years. My question is do I have to have a license or permit to do this? I only do it for the fire dept and ambulance crews that I belong to.

You have to hold the button down for a few seconds till it beeps.

they are always on ebay for under ten bucks

I tried the ign sense but won't power on. It clicks but nothing else. It is set up for Telephone Interconnect Remote Control.

It clicks but the head doeas nothing. I tried ign sense that was no help. It is setup for Telephone Interconnect Remote Control

You have to hold the add/delete button for about 5 seconds till it beeps

Most of the newer kenwood radios won't work unless you have a genuine kenwood programming cable. You need a genuine kenwood cable part # KPG-22

Check your PM'S

I am in need of the tk-830H Schematics. Does anyone know where I can find them?
Thanks Jeff

Ok I was checking some things for power and when I tuched a diode (chip) it powerd up it is on the small board where the ribbon conects and is labeled PSC. If you look at the radio from behind it is the ribbon to the left.

I just picked up a new tk-830H and it will not turn on. There is power to the main board but I checked the remote cable and all of the leads are dead. I am not a tech so I am lost anyone have any ideas.
Jeff