The Radio Information Board

I need the wiring diagram for the H16 to V-200 mobile cloning cable.
Eric N7XCF

You need the KPG-4 cable and KPG-7D software. The low split goes down too 29.700mHz but the SP tune option in the software allows direct entry of freqs down to 29.000mHz. the basic comes with 32 channels with expansion eprom 99 channels. The full featured head with expansion goes to 160 channels. Er...

MIC HANGER NOT GROUNDED IS THE MOST COMMON PROB - OR THE THE HOOK LINE BETWEEN THE MIC JACK AND MICROPROCESSOR OPEN OR SHORTED HIGH.
ERIC

If you're talking about the maxon 4000 series with the flourescent display there is a high voltage inverter circuit on the audio/logic to supply the high voltage for the display. I had one where the miniture transformer in the supply circuit went bad.
Eric

It's available on the radtek site under GE software "S990PROG.ZIP" Copy right status unknown.javascript:emoticon('')
http://radio.the161.net/images/smiles/icon_wink.gif

4Z = 136.5Hz

Yes and No. The 900 series with factory firmware has to be programmed with the notorious GE suitcase programmer or the Niles programmer. The Niles software has been released for free use (they no longer suppoert the programmer) and if you have an eeprom programmer that will do the Xicor X2816 eeprom...

Yes and No. The 900 series with factory firmware has to be programmed with the notorious GE suitcase programmer or the Niles programmer. The Niles software has been released for free use (they no longer suppoert the programmer) and if you have an eeprom programmer that will do the Xicor X2816 eeprom...