Search found 6 matches
- Fri Apr 23, 2010 7:17 pm
- Forum: Kenwood Commercial Products
- Topic: TK-2180 password
- Replies: 6
- Views: 12244
Re: TK-2180 password
Sorry, no go; it's not just the READ authorization password that's been set, it's the OVERWRITE password. Completely locked out unless we can figure out how to read the serial data stream or send it back to Kenwood. In that case, you can try WinHex. tricky though, but if you have patience you'll ge...
- Thu Apr 22, 2010 5:35 pm
- Forum: Kenwood Commercial Products
- Topic: TK-2180 password
- Replies: 6
- Views: 12244
Re: TK-2180 password
Do you have an existing 2180 file you can load to the software? if so, you can use that and then just shoot it to the radio, it will overwrite everything including the password. If you dont have an existing file, open the software and go to Model, then pick TK-2180, click OK. a warning will appear, ...
- Thu Apr 22, 2010 5:29 pm
- Forum: Kenwood Commercial Products
- Topic: TK-8180 crossbanding
- Replies: 2
- Views: 5574
Re: TK-8180 crossbanding
1. use the DB-25 pin accessory to interface an 8180 to 7180 2. 8180 pin 17 to 7180 pin 6 with a 22k resistor in the line 3. 7180 pin 17 to 8180 pin 6 with a 22k resistor in the line 4. 8180 pin 22 with 22k resistor to base of transistor (2N222A). transistor collector to 7180 pin 21. transistor emitt...
- Thu Apr 22, 2010 5:17 pm
- Forum: Kenwood Commercial Products
- Topic: tk-3160 channel knob
- Replies: 1
- Views: 3852
Re: tk-3160 channel knob
shouldn't there be a stopper. but to check, you gonna have to remove the case. to do this:
1. unscrew the 2 chassis screws
2. pull out on/off knob
3. remove front case assembly
4. pull out ch knob, should see a white plastic spacer under the ch knob.
hope this helps.
1. unscrew the 2 chassis screws
2. pull out on/off knob
3. remove front case assembly
4. pull out ch knob, should see a white plastic spacer under the ch knob.
hope this helps.
- Thu Apr 22, 2010 5:02 pm
- Forum: Kenwood Commercial Products
- Topic: CES mic for kenwood TK-690
- Replies: 2
- Views: 4382
Re: CES mic for kenwood TK-690
why CES? any special application? KMC-28 is the factory DTMF mic for the TK-690. Its noise cancelling too.
hope this helps.
hope this helps.
- Thu Apr 22, 2010 4:58 pm
- Forum: Kenwood Commercial Products
- Topic: TK-760/KPG29D Help
- Replies: 5
- Views: 7697
Re: TK-760/KPG29D Help
what kind of programming cable you have? DB-9 or DB25? original or after market?