The Radio Information Board

Please post any success. I was disappointed when my 5500 would not go 2 meters.

I have that manual. What do you need to know?

There are two versions of the N models. The circuit boards are different. I can look up something for you. The prefix number of the serial number tells which manual to use. The N models are the later models and can be computer programed.

This is an old 4 channel TK-360. Unstable VCO could be the problem. I will look around some more. I have a TK-360/N manual. Is this the correct book?

Does the TK-360 heliflex antenna have a center contact or is the stud the the contact? This radio has a very distorted and unstable PL encode tone. What could be causing this?

I have saved the programming for a dual head radio VX5500. Can I write this program to a single head radio without any problems?

I need a dual control 5500. I would like to connect the radio or one of the remote heads to a 4010 console, would it be better to use the D connector on the rear of the radio or connect to the mic connector on the head or to a connector on the side of the radio?

What is the ID number and physical location of the modulation control in a 70-1340B Syn-tech II?

Have you found a sub for the mic cable for Fujitsu 56 series mics with the modular plug?

I need to program a dual head VX-5500V. Does the cable connect to one of the heads or to the radio?

I have a VHF XTR 70-1340B with receiver sens of 1.5 microvolts. Is there any tweak or what could cause this?

I have lost my XTR manual. I have a 70-1340B radio. I am getting an intermittant E3 error code and have static in modulation when radio does transmitt. I have replaced electrolytic cap in VCO circuit and cleaned board. I have looked at PA board for overheated diodes and caps. I also cleaned mic ptt ...

Thanks Bill and Dennis. The part number is AMX120A and it fits all Uniden dash mount radios.

I need the part number for a power cable for a Uniden SMU4525KT. Relm said they might have one if I had a number to search by.

You can get a mic from a RELM dealer.