Old Post. Had somebody here on board program the ANI board. Orignally came set up for 5tone.
Frank N3OBL
FF/EMT
Search found 70 matches
- Thu Feb 09, 2006 10:22 pm
- Forum: Vertex
- Topic: VX900U with ANI-F board
- Replies: 3
- Views: 5006
- Sat Jan 28, 2006 7:58 pm
- Forum: Kenwood Commercial Products
- Topic: tk3180 Problems
- Replies: 1
- Views: 2922
tk3180 Problems
Trying to program a tk-3180 with the same cable i use for a 3140. Using ver 1.10 software and it will say program on radio screen however the computer says com error. Checked settings and then tried to read a 3140 with same cable. Worked Fine. Ser 60400087 FM ver 1.12 K Could i need an updated softw...
- Tue Jan 03, 2006 3:05 pm
- Forum: Vertex
- Topic: VX900U with ANI-F board
- Replies: 3
- Views: 5006
VX900U with ANI-F board
Purchased one off ebay. Did not know til i took battery off and wowla.. a ANI-F board.
Can this be programmed through the Programming software, to set ID Number.
Frank N3OBL
FF/EMT
Can this be programmed through the Programming software, to set ID Number.
Frank N3OBL
FF/EMT
- Mon Dec 26, 2005 8:43 am
- Forum: Kenwood Commercial Products
- Topic: TK380 adding keypad
- Replies: 8
- Views: 6678
- Mon Dec 26, 2005 1:13 am
- Forum: Kenwood Commercial Products
- Topic: TK380 adding keypad
- Replies: 8
- Views: 6678
- Fri Dec 23, 2005 3:57 pm
- Forum: Kenwood Commercial Products
- Topic: Kenwood VHF antenna?
- Replies: 1
- Views: 2753
- Fri Dec 23, 2005 3:42 pm
- Forum: Kenwood Commercial Products
- Topic: TK380 adding keypad
- Replies: 8
- Views: 6678
- Thu Dec 22, 2005 10:06 pm
- Forum: Kenwood Commercial Products
- Topic: TK380 adding keypad
- Replies: 8
- Views: 6678
TK380 adding keypad
Have a 380 that i purchased a housing and the rubber keypad for to convert to dtmf. However when i transmit it will not send DTMF on ch.
Frank N3OBL
FF/EMT
Frank N3OBL
FF/EMT
- Wed Dec 21, 2005 5:54 pm
- Forum: Vertex
- Topic: VX-537 Review
- Replies: 4
- Views: 5668
- Mon Nov 21, 2005 6:58 pm
- Forum: Kenwood Commercial Products
- Topic: Kenwood 730/630 problem
- Replies: 1
- Views: 2688
Kenwood 730/630 problem
Well I installed a 730/630 setup. Checked on bench prior to install, all good. Before install did the 160 ch upgrade. One for each radio and Ctrl Head. Went to install. LB works the VHF it low beeps and flashes. Found the ground wire off in the 730 at the ctrl head cntr. Put that back on and still d...