The Radio Information Board

We have a Zetron PageCenter paging encoder that we use at work for our irrigation system. The company that sold us the encoder (it is rebranded as Toro) failed to give us any manual besides the crap that they wrote on how to turn it on and off.

What we need to figure out is how to get into the configuration menu (not the program menu) to setup our autopatch and call in, freq setup, and afew other settings. I have tried the Zetron website, no luck for a manual. Is there some special key combo to use to get to this menu? or our we going to have to have someone come out and do it for us?



Thanks for reading


.z

These guys here apparently still sell the device. I don't know who makes it (or made it).. apparently it was not a Zetron product. In a quest for a paging terminal recently I tried to get the Zetron unit but they had discontinued it.. they said the RF transmit module was no longer available.
In any event, here's another place to look for a manual.

http://www.vytek.com/products/pbw/pf2.htm

Sam