Cushman CE-50 service monitor help needed!!!
Posted: Sun Feb 12, 2006 8:01 pm
Hi,
I have a slightly sick Cushman CE50-TG-1 service monitor and was wondering if anyone has taken any voltage readings from a working unit they would be willing to share.
I need to check the voltages at test points 3 & 4 on the 29000 board with the frequency set between 9.9999mhz and 100khz. That should give me the normal range for both the A & B VCO's control voltage's. (referenced to chassis ground) Any other voltages would also be helpful so I can note them for future reference.
Sure would have been nice if Cushman would have provided some basic voltage readings on the schematics.
I have a manual and have read the theory of operation MANY times but the voltages are not stated either on the schematic or theory.
Any help would be appreciated,
Thanks,
RoD
I have a slightly sick Cushman CE50-TG-1 service monitor and was wondering if anyone has taken any voltage readings from a working unit they would be willing to share.
I need to check the voltages at test points 3 & 4 on the 29000 board with the frequency set between 9.9999mhz and 100khz. That should give me the normal range for both the A & B VCO's control voltage's. (referenced to chassis ground) Any other voltages would also be helpful so I can note them for future reference.
Sure would have been nice if Cushman would have provided some basic voltage readings on the schematics.
I have a manual and have read the theory of operation MANY times but the voltages are not stated either on the schematic or theory.
Any help would be appreciated,
Thanks,
RoD