Cushman CE-50 service monitor help needed!!!

Talk about anything that doesn't fit in a topic below - Also used for board announcements.
Post Reply
rodnsue
Posts: 14
Joined: Sun Feb 12, 2006 7:54 pm

Cushman CE-50 service monitor help needed!!!

Post by rodnsue » Sun Feb 12, 2006 8:01 pm

Hi,
I have a slightly sick Cushman CE50-TG-1 service monitor and was wondering if anyone has taken any voltage readings from a working unit they would be willing to share.
I need to check the voltages at test points 3 & 4 on the 29000 board with the frequency set between 9.9999mhz and 100khz. That should give me the normal range for both the A & B VCO's control voltage's. (referenced to chassis ground) Any other voltages would also be helpful so I can note them for future reference.
Sure would have been nice if Cushman would have provided some basic voltage readings on the schematics.

I have a manual and have read the theory of operation MANY times but the voltages are not stated either on the schematic or theory.

Any help would be appreciated,
Thanks,
RoD

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest