VX900U with ANI-F board

n3obl · Post by **n3obl** » Tue Jan 03, 2006 3:05 pm

Purchased one off ebay. Did not know til i took battery off and wowla.. a ANI-F board.

Can this be programmed through the Programming software, to set ID Number.

Frank N3OBL
FF/EMT

Muggsy09 · Post by **Muggsy09** » Thu Feb 09, 2006 3:17 pm

Depends on the model of the board, the software you're using and the radio. The board I have (purchased off ebay) does MODAT signalling cannot be programmed through the software, the ID number was pre-programed and then enabled in the software.

RadioTweester · Post by **RadioTweester** » Thu Feb 09, 2006 9:12 pm

Frank

The ANI-F board is manufactured by Midian - http://www.midians.com - and will need to be programmed outside of the radio with Midian's KL-3 Programmer and the VPI-1 interface. Here's the link to the board page http://www.midians.com/html/specspage.a ... +Signaling

The Cimarron - http://www.cimtechcorp.com - boards can be programmed while they're in the radio using Vertex's CE-73 software. I really like the VMDE-200 because it also decodes, but the ANI-F will does a lot more functions and as a freebie vs $130; heck, that's very COOL.

-Tom

n3obl · Post by **n3obl** » Thu Feb 09, 2006 10:22 pm

Old Post. Had somebody here on board program the ANI board. Orignally came set up for 5tone.

Frank N3OBL
FF/EMT