Questions on 4200 scan
Questions on 4200 scan
Hey guys I am trying to get this thing to scan but not have the big skip when it stops on a channel other than my pri channel ....the only thing I have found that works is to just take off the pri ....but I really dont want to do that. Any Ideas?
-
- Posts: 50
- Joined: Fri Aug 19, 2005 5:13 pm
- Location: Portland, Oregon
The short answer... No.
You can extend the time your priority channel is checked (under [Common] --> [Scanning] --> [Scan Parameters] it's from 1/2sec to 3sec check time).
Another idea is to leave priority off and mess with the [Scan time 1] time. Maybe down to 1/4 second. (Not really a solution I know).
I'll post another reply if I find a way to do what you're looking for but it doesn't lookvery good.
-Tom
You can extend the time your priority channel is checked (under [Common] --> [Scanning] --> [Scan Parameters] it's from 1/2sec to 3sec check time).
Another idea is to leave priority off and mess with the [Scan time 1] time. Maybe down to 1/4 second. (Not really a solution I know).
I'll post another reply if I find a way to do what you're looking for but it doesn't lookvery good.
-Tom