VX-920 2 tone decode problems

Forum dedicated to discussion on Vertex Commercial Radio products
Post Reply
silverbk
Posts: 52
Joined: Sat Oct 23, 2004 6:05 pm

VX-920 2 tone decode problems

Post by silverbk »

Hello,

I am setting up a vx-920 in VHF for a volunteer FF. I want to have the radio setup on one channel for off duty 2 tone paging on his depts tones.

Can anyone recommend a good trusted set up parameters to get this to work?

Right now I have it working, but when the radio opens it seems to stuck at a reduced volume. I can't seem to find which parameter is causing this.

Any help appreciated.
radio259
Posts: 137
Joined: Sun Aug 01, 2004 7:11 pm
Location: Pittsburgh Pa

Re: VX-920 2 tone decode problems

Post by radio259 »

The only possibility could be the call beep level. I have mine set at 6. I looked thru both my 820 and 920 and both are set the same. If that does not work, e-mail me a copy of the programmign, I can dump it in my radio and try to finger it out.,

Paul B
silverbk
Posts: 52
Joined: Sat Oct 23, 2004 6:05 pm

Re: VX-920 2 tone decode problems

Post by silverbk »

I tried the beep level parameter with no luck.

This is a link to the codeplug

http://download.yousendit.com/8F6985593013247F

Maybe if you get it to work, It could be a hardware or firmware problem with this radio.
Post Reply