CE99 dealer mode?

Forum dedicated to discussion on Vertex Commercial Radio products
Post Reply
n5tbu
Posts: 411
Joined: Fri Aug 30, 2002 7:20 am
Location: Opelousas,La.

CE99 dealer mode?

Post by n5tbu » Tue Dec 20, 2011 4:04 pm

I would like to gain access to the grayed out menu items.
I tried the -d trick....no go.
Mark

okietech
Posts: 3
Joined: Wed Dec 28, 2011 3:56 pm

Re: CE99 dealer mode?

Post by okietech » Thu Dec 29, 2011 4:58 pm

Space, dash, d (_-D) or just dash d? and did you try it from Vertex Standard, under all programs? For CE60, you have to run from there also.

n5tbu
Posts: 411
Joined: Fri Aug 30, 2002 7:20 am
Location: Opelousas,La.

Re: CE99 dealer mode?

Post by n5tbu » Thu Dec 29, 2011 5:18 pm

Yes,I used the space-d.
The CE60 has a dealer and a factory mode up at the top,the CE99 doesn't.

n5tbu
Posts: 411
Joined: Fri Aug 30, 2002 7:20 am
Location: Opelousas,La.

Re: CE99 progress

Post by n5tbu » Wed Jan 11, 2012 10:10 am

New progress....
Reading through CE99 in Hex Workshop,I found a few sentences about manufacture mode.
So if you put space-s after ce99exe,it asks for a password.
Anyway,if you enter the wrong password or no password.ce99 starts up in regular mode.
If you enter tokusyu-bango,ce99(S) starts up,so I know I am in Manufacture Mode.
Also if you put space-manu it asks for a password too,but it is a different one than the one above.
I have no idea yet how to get the faded out boxes to open up for changing.
Hope this helps someone trying to hack the newer versions of software

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests