VX-4207 Ignition Sense

Forum dedicated to discussion on Vertex Commercial Radio products
Post Reply
Posts: 1
Joined: Sat Jun 23, 2012 11:17 am

VX-4207 Ignition Sense

Post by dan3284 »

I have a used radio that has been setup for Ignition Sense on Pin 8 of the DB15 connector. I am used to Kenwood stuff where that feature gets enabled and disabled in software, but I cannot find anything in the software, nor by searching online, that indicates how to tell the radio whether to pay attention to Pin 8 or not. Anyone know?

Posts: 12
Joined: Sun Mar 15, 2009 9:46 am

Re: VX-4207 Ignition Sense

Post by rfcom »

In the software, under Common and DSUB-15, your ACC I/O Port 1 Input is programmed for Ignition. change it to none (or any other option) and you will not need to have 12V on this input to power up the radio.

Post Reply