Page 1 of 1

VX-4207 Ignition Sense

Posted: Sat Jun 23, 2012 11:46 am
by dan3284
I have a used radio that has been setup for Ignition Sense on Pin 8 of the DB15 connector. I am used to Kenwood stuff where that feature gets enabled and disabled in software, but I cannot find anything in the software, nor by searching online, that indicates how to tell the radio whether to pay attention to Pin 8 or not. Anyone know?

Re: VX-4207 Ignition Sense

Posted: Fri Jun 29, 2012 10:08 am
by rfcom
In the software, under Common and DSUB-15, your ACC I/O Port 1 Input is programmed for Ignition. change it to none (or any other option) and you will not need to have 12V on this input to power up the radio.