VXR-7000U can't change "Tx Inh" on transmit frequency
Posted: Fri Nov 09, 2018 5:56 pm
Howdy.
We just acquired a used Vertex VXR-7000U and it works great except that I cannot change the transmit frequency on 2 channels. It reads "Tx Inh", which I assume means "Transmit Inhibit". It will let me temporarily enter the frequency but will revert back if I open a menu or write to the radio. I took a peek at the transmit levels by channel but all of them are set the same (0).
- CE27 v1.01 both in dealer mode ("-d) and in user mode
- Firmware v1.19
- Windows 7 64 bit
- Good quality USB cable
- Only channel #2 and channel #3 affected
I can successfully change other settings and channels. I am guessing one of three things:
1) There is a setting that I am missing.
2) The codeplug is corrupt.
3) It was written with a more recent program.
I am working to get v1.08 (international - need wideband). I'm thinking of looking at the codeplug with a hex editor and seeing if there is a discernible pattern to edit it. Anyone have any thoughts, comments, or advice?
Thanks.
We just acquired a used Vertex VXR-7000U and it works great except that I cannot change the transmit frequency on 2 channels. It reads "Tx Inh", which I assume means "Transmit Inhibit". It will let me temporarily enter the frequency but will revert back if I open a menu or write to the radio. I took a peek at the transmit levels by channel but all of them are set the same (0).
- CE27 v1.01 both in dealer mode ("-d) and in user mode
- Firmware v1.19
- Windows 7 64 bit
- Good quality USB cable
- Only channel #2 and channel #3 affected
I can successfully change other settings and channels. I am guessing one of three things:
1) There is a setting that I am missing.
2) The codeplug is corrupt.
3) It was written with a more recent program.
I am working to get v1.08 (international - need wideband). I'm thinking of looking at the codeplug with a hex editor and seeing if there is a discernible pattern to edit it. Anyone have any thoughts, comments, or advice?
Thanks.