Problems programming older EFJ5300 mobile

Forum dedicated to discussion on EF Johnson Radio products

Moderator: willbartlett

Post Reply
emt.micah
Posts: 5
Joined: Wed May 23, 2012 10:55 pm

Problems programming older EFJ5300 mobile

Post by emt.micah » Thu May 24, 2012 9:24 am

I have an older EFJ5300. It was manufactures in 03 or 04. When I turn it on I get the following version numbers: 3.17.21 then 1.26.3.

I have PCConfig 2.1.0 and 1.28.0.3. When I attempt to read or write the radio, the PCC indicates its working, but nothing seems to happen after even 5 or ten minutes. I know the computer is talking to the radio, because if I unplug the programming cable while PCC indicates it's busy, the software spits out an error indicating it lost comms with the radio.

Any ideas?

Micah

W0VNE
Posts: 33
Joined: Fri Apr 17, 2015 1:51 pm

Re: Problems programming older EFJ5300 mobile

Post by W0VNE » Fri Oct 09, 2015 3:49 pm

I'm not certain as thats a version number I've not seen. I think you have a version 1 5300 which is ARM based.

5300 ARM DSP FIRMWARE BOOT PCC
Version 1 (ARM) 1.32.11 1.64 N/A 1.10/1.12 1.30.7

I think PCC 1.28.0.8 is another version to try.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests