I have 3 800 Mhz MDX mobiles and have a problem with the programming. The first one read and wrote properly, but the second and third have had problems. Both were put into programing mode, but would not handshake. When I powered them off and back on, both powered on in program mode without holding any keys. I eventually got one to write, but after programming, it still powers up in program mode. Is there a way to reset them? On some good advice, I removed the front covers to make sure there were no stuck buttons, and both were clean.
I am using Programmer ver 9, factory cable and Price Industries P96A.
I suspect it is a problem with the Price interface box, I noticed that the led status lights seem to blink at different times during read/write, but I can't be sure. Any help would be appreciated