Does anyone have a PDF of the correct programming cable for an Orion? I believe that the one on the Hall site is missing a couple of resistors and a jumper to make it work.
I thought I had a diagram, but can't seem to locate it.
Jim
Orion Programming cable diagram
Re: Orion Programming cable diagram
OK, found my diagram. Info for those that are still using the GE interface box, with a few mods to the programming cable, you can plug the cable directly into your serial port of your computer. Don't need the interface box for this radio any more.
Jim
DB37 - - - - - - - - - - - - BD9
2 120 ohm resistor - - 3 RXD
3 120 ohm resistor - - 2 TXD
7 - - - - - - - - - - - - - - 5 GND
7 diode cathode
8 diode anode
8 100 ohm resistor
25 other end of 100 ohm resistor
6 - - - - - - - - - - - - - 7 RTS
20 - - - - - - - - - - - - 8 CTS
Jim
DB37 - - - - - - - - - - - - BD9
2 120 ohm resistor - - 3 RXD
3 120 ohm resistor - - 2 TXD
7 - - - - - - - - - - - - - - 5 GND
7 diode cathode
8 diode anode
8 100 ohm resistor
25 other end of 100 ohm resistor
6 - - - - - - - - - - - - - 7 RTS
20 - - - - - - - - - - - - 8 CTS