Icom IC-2GAT - no Xmit

Forum dedicated to discussion on Icom Amateur Radio products
Post Reply
n1dec
Posts: 1
Joined: Mon Feb 12, 2018 3:06 pm

Icom IC-2GAT - no Xmit

Post by n1dec » Mon Feb 12, 2018 8:45 pm

Hello to all Icom fans.
I have acquired what seemed to be a good old IC-2GAT.
Everything seemed fine. Memories work, RX works, etc.
But when I go to XMIT the display and the XMIT LED flash at a about a
5hz rate. No output is detected.
I tried all frequencies and modes.
I tried to reset the unit by holding the function and light switches in for a while to not effect.
Battery looks good.
Anyone have any ideas?

fineshot1
Posts: 80
Joined: Tue Jun 27, 2006 8:20 pm

Re: Icom IC-2GAT - no Xmit

Post by fineshot1 » Tue Feb 27, 2018 11:52 am

Sounds like the battery is unable to supply enough current capacity
or if you are using a power supply its not able to handle the load.
Without anymore info that is all i can suggest.
fineshot1
NJ USA

n5tbu
Posts: 411
Joined: Fri Aug 30, 2002 7:20 am
Location: Opelousas,La.

Re: Icom IC-2GAT - no Xmit

Post by n5tbu » Sun May 20, 2018 11:57 am

ICOM,I Can Only Monitor

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest