I would lke to use a STAMP type chip to exchange data with ICOMs rigs (HF Transceivers) to determine the rigs frequency.
I believe the data is serial TTL in/out of the ICOM rigs so there is no need to do any level changes as I can operate the STAMP chip at those levels.
Has anyone "talked" to ICOM radios directly and not via a laptop? If so, what methods/hardware did you use.
Thanks in advance
pcb4u at verizon dot net
Forum dedicated to discussion on Icom Amateur Radio products
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests