F4061S Scan Setting help????

Forum dedicated to discussion on Icom Commercial Radio products such as F70, F80, F1721, F2821, F9011, F9021, F9411, F9521, F9511HT.
Post Reply
RADIO43
Posts: 19
Joined: Tue Oct 12, 2004 6:48 pm
Location: BEST PLACE IN THE WORLD

F4061S Scan Setting help????

Post by RADIO43 »

Guys,

Help.


I am trying to figure out these scan setting but have been unable to.

I want the radio when scanning to remain on the channel that I activate the scan on and then key up on that channel when I hit the transmit button. Right now, the radio TX's on whatever the last channel is that the radio landed on when in scan. It does not matter if the transmission ended 2 seconds or 30 seconds on that channel.

Example

1. Radio started on Channel 1...
2. Radio receives traffic on Channel 4...
3. Radio now reverts to Channel 4 when you key up...
4. Radio also if you deactivate scan reverts to channel 4....

I have played with some settings including , "Talk back" to 0 seconds and it is still doing it...


Any help is appreciated...

radio43
jsikora
Posts: 99
Joined: Thu May 12, 2005 12:51 pm

Re: F4061S Scan Setting help????

Post by jsikora »

do you have your priority set for channel select ? also what scan mode do you have setup ? There are many settings in the radio to do with scan.
can ya hear me now...
RADIO43
Posts: 19
Joined: Tue Oct 12, 2004 6:48 pm
Location: BEST PLACE IN THE WORLD

Re: F4061S Scan Setting help????

Post by RADIO43 »

How do you set up the priority for the Select channel? I believe this is my issue. I see things like "PriorityA" and what not...

I believe if I can get it on selected channel prioruty, that would solve the problem. Channel select meaning the channel the dial is select on...

Thanks again for the help....
Post Reply