TM-271A problem

Forum dedicated to discussion on Kenwood Amateur Radio products

Moderator: willbartlett

Post Reply
dpd4703
Posts: 2
Joined: Wed Apr 05, 2006 3:29 am

TM-271A problem

Post by dpd4703 » Wed Apr 05, 2006 3:34 am

We have a TM-271A mounted in a vehicle that receives perfectly but when the PTT is pressed the radio shuts down and powers back up. The antenna checked out good and it shows 12 volts coming in through the power cord.

Any suggestions on what to check or what may be the problem? Thanks for any ideas.

User avatar
n9gik
Site Supporter
Posts: 98
Joined: Sun Aug 01, 2004 12:41 am
Location: SE IL

First place I would look

Post by n9gik » Thu Apr 06, 2006 8:22 am

Simply because it is easiest the first place I would look is the power cable. Is it heavy enough? Does the connection have the capability to handle the current you are drawing?

Dad put a 45 watt business radio in his truck and plugged it into the cigarette lighter, then wondered why it didn't work right.

I have seen wires that would test good, but had broken conductors that would not allow enough current through to handle the load. Heard a Xerox tech discuss that one time. He spent an entire day on the floor of an office tracing wires in a copier. Found one that tested good but wouldn't work. When he stripped it back he found one strand of wire was all that was still connected.
I don't know much about 2-way radios but I'm over 50 and can't remember not having one around. Everything from Buddy and Citi-fone to Icom and Kenwood.

k2hz
Posts: 150
Joined: Sun Jan 30, 2005 1:02 pm
Location: Rochester, NY

Post by k2hz » Thu Apr 06, 2006 8:30 am

That is usually a symptom of high resistance somewhere in the power wiring. The voltage is ok on RX but the higher TX current results in so much voltage drop that the radio shuts down. Look for a corroded plug or connector, a splice not properly crimped, poor ground connection, etc..

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests