TK-380 cracked display

Forum dedicated to discussion on Kenwood Commercial Radio products

Moderator: willbartlett

Post Reply
ltec123
Posts: 8
Joined: Tue Jan 22, 2002 8:00 pm

Post by ltec123 »

Hi guys,

How hard is it, if possible to change the display on a TK-380.

And while your'e at it, the part numbers.

Thanx
micor47
Posts: 3
Joined: Sat Feb 09, 2002 8:00 pm
Location: Your TOTAL Motorola-Kenwood Sales-Service Dealer Lowest Prices Anywhere

Post by micor47 »

It is not hard at all. Take the screws that hold the chassis out there are only two. Next with a small screwdriver carefully pry out the chassis from the housing. Next remove the rubber housing that contains the speaker and dtmf pad if you have dtmf. Next remove the six screws that hold the front board to the chassis. Carefully pry up the two ribbon cables that are attached to the mainboard then you can remove the front board that contains the display. The display is attached to the front board via another ribbon cable and plastic tabs. Just remove these and there you are. Assembly is just the reverse. The part nuber for the display is :
B38-0810-05.

Rich
ltec123
Posts: 8
Joined: Tue Jan 22, 2002 8:00 pm

Post by ltec123 »

Thanks.

Do you know any better/cheaper place to buy Kenwood parts then http://www.kenwoodparts.com.?

Thanks

PS I am not a Kenwood dealer...
micor47
Posts: 3
Joined: Sat Feb 09, 2002 8:00 pm
Location: Your TOTAL Motorola-Kenwood Sales-Service Dealer Lowest Prices Anywhere

Kenwood Parts

Post by micor47 »

We are a kenwood dealer and if you need parts you can call us toll free and we either may have the part in stock or can order it.
1-800-264-1175 ask for Robert or Rich
ltec123
Posts: 8
Joined: Tue Jan 22, 2002 8:00 pm

Post by ltec123 »

Hi Rich,

Thanks again, will do!

Lt
Post Reply