ignition sense wiring help TK-790

Forum dedicated to discussion on Kenwood Commercial Radio products

Moderator: willbartlett

Post Reply
stangmansvo
Posts: 44
Joined: Fri Dec 19, 2003 10:54 pm
Location: western maryland

ignition sense wiring help TK-790

Post by stangmansvo »

Hi all
Im looking for help to setup a TK-790 remote head radio to ignition sense.
thanks
steve :(
Im a certified radio holic !
User avatar
Meatball
Posts: 147
Joined: Tue Mar 21, 2006 6:28 pm

Post by Meatball »

The ignition sense lead goes into pin 1 of the head accessory connector. Fuse for 3A.

Remove R504 and move it to the blank pads for R506. This is a surface mount component and care must be taken (I use a small pair of low-wattage soldering irons).

R504 is located on the right side of the top PC board.
Post Reply