tk-630 ctcss code not working

1894 · Post by **1894** » Thu Nov 09, 2006 12:47 am

I am trying to figure out why the pl codes that i have entered are not working. is there a special board or chip that is needed?

ka7wnf · Post by **ka7wnf** » Thu Nov 09, 2006 6:55 pm

Nope, it should work if programmed correctly. there some adjustments for tone and balance for PL but you need a scope to do it right. Peter

KF4SQB · Post by **KF4SQB** » Thu Nov 09, 2006 11:36 pm

Do you have the hang-up button on the back of the mic grounded? If not, the radio thinks it is "off-hook", and is in monitor (PLs defeated).

1894 · Post by **1894** » Fri Nov 10, 2006 7:48 pm

Thanks for the information...I think it has to do with the Off Hook as mentioned...

ohgary · Post by **ohgary** » Fri Nov 10, 2006 9:39 pm

You can program the tone to ignore the hangup signal.