TK-890 Radio # 2 of Dual Band to Single Band

Forum dedicated to discussion on Kenwood Commercial Radio products

Moderator: willbartlett

Post Reply
shorty604
Posts: 2
Joined: Sun Feb 22, 2009 12:59 pm

TK-890 Radio # 2 of Dual Band to Single Band

Post by shorty604 »

Have a TK-890H that was part of a dual band single head set up. It is radio # 2 and I would like to get radio to power up
with out going back to previous set up. I have the kit to change to single band dual remote heads. I have done this and the radio will not power up.
I don't have the other radio to put back in dual band config.
Any help is appreciated
Elighting
Posts: 54
Joined: Fri Feb 03, 2006 7:25 pm
Location: Chattanooga,TN/Bryant,AL

Re: TK-890 Radio # 2 of Dual Band to Single Band

Post by Elighting »

As I said in the other post, you have to solder in 3 jumpers and 1 micro fuse. I had to do this on my 890 setup as well to upgrade the firmware. Our service tech can perform this service for you for a small fee. I'll check and see how much it would cost to do this. Thank you.

Jordan,TCFD.
Post Reply