I have a few TK-730's with Dual Heads and the MDC1200 Option installed.
When trying to read the radio, the radio beeps and shows "Error" on the screen. At times it counts down 7k, 6k, 5k etc. then goes to error.
I tried 2 different computers, both with "real" COM ports and 2 different cables. I have tried all of the radio types in the software. I tried 2 different radios as well.
Can this be because of the MDC option boards?
Any other advise?
Thanks
TK-730 Dual Head, MDC1200 - Programming Problem
Moderator: willbartlett
-
- Posts: 68
- Joined: Tue Jun 03, 2003 8:23 pm
- Location: North Carolina
Re: TK-730 Dual Head, MDC1200 - Programming Problem
Sounds like you have a eeprom size error.
Make sure that the model selected in the software exactly matches the radio model you are reading. Options are:
Basic 32 channel
Basic 99 Channel
Basic 32 channel with Alpha
Basic 99 Channel with Alpha
Full 32 channel
Full 160 channel
Also make sure you are running with a slow computer in true DOS mode, no Windows.
Make sure that the model selected in the software exactly matches the radio model you are reading. Options are:
Basic 32 channel
Basic 99 Channel
Basic 32 channel with Alpha
Basic 99 Channel with Alpha
Full 32 channel
Full 160 channel
Also make sure you are running with a slow computer in true DOS mode, no Windows.
Andy
--------------------------------------------------------------
NC Certified Firefighter III / EMT-A
FCC Licensed Technician / Amateur Call NC4AB
http://www.brinkleyelectronics.com
--------------------------------------------------------------
NC Certified Firefighter III / EMT-A
FCC Licensed Technician / Amateur Call NC4AB
http://www.brinkleyelectronics.com
Re: TK-730 Dual Head, MDC1200 - Programming Problem
I tried every option in the software.
Also, I am using an old Toshiba Libretto 50CT in true DOS mode.
Also, I am using an old Toshiba Libretto 50CT in true DOS mode.