Forum dedicated to discussion on Kenwood Commercial Radio products
- Posts: 1
- Joined: Tue May 24, 2016 4:17 pm
From the service manual, you adjust VR1 & VR2 on the Final board. But is there any specific order or method to the adjustments? I want to take down the 110 watts to 60 or so.
- Posts: 29
- Joined: Tue Nov 15, 2005 12:37 pm
I don't know the answer to your question.
But if you want 60 watts *or so* why not set the channel to low power which is about 50 watts IIRC?
- Posts: 413
- Joined: Fri Aug 30, 2002 7:20 am
- Location: Opelousas,La.
There is no low power setting on the 30 series in software.
The 90 series does have a high/low.