Hi,
I have a Kenwood TK730 mobile radio that was originally connected with the main power and ground wires only, and wired hot.
I want to have the radio turn on/off with the ignition key but with the main power wire connected to ingnition I have to manually turn on using the radio power button.
I am pretty sure there is an ignition sense connection on the back of the radio's 15 pin accessory connector but I am not sure what pin it is. What is required to setup this radio to turn on/off with ignition key and not have to hit the power button of the radio?
Thanks for any help, Dave.
TK 730 Ignition Sense
Moderator: willbartlett
TK730 Ignition Sense
Remove top cover from radio (the smaller of the two covers) and cut W101. On the 15 pin connector on the rear, run accessory B+ to pin 3. This should do it.
TK730 Ignition Sense
Thanks Kenwoody,
I'll give it a try.
I'll give it a try.
Kenwoody wrote: Remove top cover from radio (the smaller of the two covers) and cut W101. On the 15 pin connector on the rear, run accessory B+ to pin 3. This should do it.