Hi Everyone
I have had a Nabishi 9100l radio for some time now (pmr) but never found any info about it.
What i need is some help on the diode arrangments for setting it onto 4m or 70cm?
could anyone help with this little problem??????
Thanks
Tom
Nabishi
nabishi diodes
Formula for VHF Ch1 Rx 167.9625 same maths for low band.
N= 167.9125 - 164.0 Over 0.0125 = 314
EG. N = required freq - Base freq overStep freq
Step freq =0.0125 for Hi & Low band
Base freq for Hi is164.0mHz
Base freq for Low is 63.5 mHz
It is 10 15 byears since I worked on one
N= 167.9125 - 164.0 Over 0.0125 = 314
EG. N = required freq - Base freq overStep freq
Step freq =0.0125 for Hi & Low band
Base freq for Hi is164.0mHz
Base freq for Low is 63.5 mHz
It is 10 15 byears since I worked on one
Hi 500e ?
Thanks for the reply
But can i just say I have no idea what you mean lol
This Radio has a diode matrix that has 48 diodes in a sqare
D0-D5 reading down one side and CH 1-8 along the bottom.
From what i can gather it all depends on witch diodes are connected or diss-connected that gives the desierd freq for channels 1-8??
Any help would be great
Thanks
Tom
Thanks for the reply
But can i just say I have no idea what you mean lol
This Radio has a diode matrix that has 48 diodes in a sqare
D0-D5 reading down one side and CH 1-8 along the bottom.
From what i can gather it all depends on witch diodes are connected or diss-connected that gives the desierd freq for channels 1-8??
Any help would be great
Thanks
Tom