Page 1 of 1
Programming cable for Kenwood TM-271A Radio P/n PG-5D
Posted: Wed Aug 04, 2004 1:15 pm
by David Odell
Does anyone have the schmatic for the above listed cable or a resource to get the specs on how to build one. Cost for factory cable is $79.00. Most of us can build anything if we put our mind to it.
Thanks
Posted: Tue Jul 19, 2005 11:27 am
by Glenn
Any luck for the wiring? I to have the 271A and would like to make up a cable......
271A programing cable
Posted: Sun Oct 30, 2005 10:51 am
by crowltom
Hello
Its more then getting the wires to the correst pins
I open my cable up to see way they used a 25 pin connnector
I was going to change it over to a 9 pin one
There is one big IC inside and 2 smaller chips
If you want I can draw out the wires to pins but on the chips
not sure where you would go to find them
.
Posted: Sat Nov 05, 2005 9:07 pm
by suwanneecomm
Heres a link to one that should work
http://www.cqham.ru/uniprog2_eng.html
personally i use the following no problems with any radios yet
http://www.makinterface.de/index_e.php3
tm-271a
Posted: Tue Jan 17, 2006 7:59 am
by wiz706
i have used these cables and have had no problem 21.95 shipped
wiz706
http://www.citlink.net/~wiz706/prod04.htm