Kenwood 260g programing problem.

akiss · Post by **akiss** » Thu Jul 14, 2005 6:17 pm

i have a problem with this device.When i m trying to program, i see a message saying : check connection.take radio out of scan and out of transmit.i have the original cable and also i make one by myself.both cables give the same error.Please help me.
thanks in advance.sorry for my bad english.

akiss · Post by **akiss** » Mon Jul 18, 2005 6:40 pm

thanks for your answer
i know about this
all my efforts are with ms-dos 6.22
any other suggestion?

n5tbu · Post by **n5tbu** » Tue Jul 19, 2005 8:48 pm

When it gives you the option to retry....say yes a few times till it goes through.
mod

akiss · Post by **akiss** » Fri Jul 29, 2005 6:21 pm

n5tbu wrote:When it gives you the option to retry....say yes a few times till it goes through.
mod

nothing happend.

n5tbu · Post by **n5tbu** » Fri Jul 29, 2005 6:25 pm

What software are you using and what version?
mod

akiss · Post by **akiss** » Fri Jul 29, 2005 6:29 pm

n5tbu wrote:What software are you using and what version?
mod

i have buy KPG-67D, and i have also try with 27d-56d
tnx for your reply

nmfire10 · Post by **nmfire10** » Mon Aug 01, 2005 12:09 pm

The 60 and 70 series radios use KPG-56D and there is even a windows version out for it now.

500e · Post by **500e** » Thu Oct 27, 2005 6:47 pm

you should be able to use KPG 67d if the check sum is correct for the prog.
it is always better to upgrade the firmware to the latest version.
In the uk it is 5TO_13F2.HEX. Check sum is 13F2 (ch this first)
Remember to enable the firmware programing in options \ mode
Change FirmWare to enable and d\load old prog with enabledSWITCH OFF. hold both function buttonsdown & SW on hold buttons till led goes green you have to have FPRO and the HEX file loaded it should be in the 56d or the 67d software and usualy loads automaticaly Check if you have latest HEX could be different for your unit? Go program\firmware prog Follow instructions help =F1
.
We also have had problems getting sets to read\write strange thing, will write ok 4\5 times then wont within a few minutes says ch con \cable .
we find thar switching OFF comp usualy puts it write, wqe have a 386 running DOS 6.22 ONLY and it still screws on occasions. both 56 and 67 are also on Win 95 & 98SE and work out of windows most of time .
soft = 56d Ver2.00 2000
soft= 67d Ver2.11 2003 this may not help but "

n5tbu · Post by **n5tbu** » Thu Oct 27, 2005 8:14 pm

Try writing a new program from your latest software,then dump it in.You also could have dirty/intermittant conections on the programming cable.
mod