LPE-200 Programming - Trunked
LPE-200 Programming - Trunked
I'm trying to program an LPE-200 for receive only on a trunked system, but can't even access the P25 screens in Programmer (all of the P25 stuff is shaded out).
I know the radios will TX Provoice as it has some simplex channels in it. I also see Option 29 listed in the Options screen.
When I try to add a new system, the only options that are not shaded out are "Conventional" and "EDACS".
Is there a reason that I can't seem to access the screens that I need? Is there something that I'm doing wrong?
Thanks!
I know the radios will TX Provoice as it has some simplex channels in it. I also see Option 29 listed in the Options screen.
When I try to add a new system, the only options that are not shaded out are "Conventional" and "EDACS".
Is there a reason that I can't seem to access the screens that I need? Is there something that I'm doing wrong?
Thanks!
Scott
http://www.radioreference.com/modules.p ... B&sid=3398
So will I be able to hear this system with my LPE-200?
So will I be able to hear this system with my LPE-200?
Scott
Well, your link says the system is running ProVoice. If your LPE is enabled to do ProVoice, you should be able to hear it. Again, though, the radio has to come from M/A-COM with that feature enabled. M/A-COM radios come from the factory with options that are enabled through a "feature encryption" string that's tied to the radio's ESN.
If the radio has the ProVoice ProVoice option, and the agency is not using encryption, you should be able to listen. You will need to configure the digital voice options in the radio's personality.
If the radio has the ProVoice ProVoice option, and the agency is not using encryption, you should be able to listen. You will need to configure the digital voice options in the radio's personality.
I think that will do it. I don't have the software in front of me, but you should be able to select "Provoice" under the system screen as the vocoder, and then on each talkgroup, you have a choice of analog, "forced on," and "switchable" (or something like that). You can either force the digital on per talkgroup, or if you leave it switchable, you'll need to define one of the keys to switch from digital to analog.
I'll double-check the Programmer screens tomorrow when I'm back in the shop.
MA-COM ProGrammer has a nasty habit of requiring you to enable 5 different things on 5 different submenus, and I never can remember all of them unless I'm looking at the program.
I'll double-check the Programmer screens tomorrow when I'm back in the shop.
MA-COM ProGrammer has a nasty habit of requiring you to enable 5 different things on 5 different submenus, and I never can remember all of them unless I'm looking at the program.
1. SYSTEMS > SYSTEM SETUP > EDACS
Set Private Voice Options
Vocoder=AEGIS
ICALL/PHONE VOICE MODE=Unencrypted
Key Bank=Disable
2. SETS > GROUP SETS > EDACS
For each group, under Group Options, Voice mode, select UNENCRYPTED.
3. OPTIONS > DIGITAL VOICE OPTIONS >Encryption > "Forced On" (AffectsTX Only. Radio will always receive analog or digital transmissions on any talkgroup)
Set Private Voice Options
Vocoder=AEGIS
ICALL/PHONE VOICE MODE=Unencrypted
Key Bank=Disable
2. SETS > GROUP SETS > EDACS
For each group, under Group Options, Voice mode, select UNENCRYPTED.
3. OPTIONS > DIGITAL VOICE OPTIONS >Encryption > "Forced On" (AffectsTX Only. Radio will always receive analog or digital transmissions on any talkgroup)