FTL-2011 problem programming
FTL-2011 problem programming
Here's the problem. I have it set up like this...Computer (CE5 v4.10), Cable (Bought for VX-2500, but states it will work for *011 series), Radio. When I try to read the radio, I get "press space", "Press A (or MON)", "Problem Detected With Connection". This happens everytime, reading or attemting to write. Am I completely not getting the picture or what's going on?
Re: FTL-2011 problem programming
I am getting the same message. Is there anything I can do to slow the computer down so I do not get this message and I can program the radio.
Re: FTL-2011 problem programming
You don't necessarily need a slow computer. You do need DOS, real DOS not a DOS window. Double check your software to make sure it is set to the correct com port.
You can easily make a DOS boot disk or floppy and then run your software.
As far as slowing things down there is a program called moslow, but I don't have any experience with it.
You can easily make a DOS boot disk or floppy and then run your software.
As far as slowing things down there is a program called moslow, but I don't have any experience with it.
Re: FTL-2011 problem programming
Can anyone tell me how to change the default com port setting in the programming software. My computer is using com port 2 for the serial port and the software is set on com port 1. Any help would be appreciated.
Thanks
Jason
Thanks
Jason
-
- Posts: 7
- Joined: Thu Dec 27, 2007 9:48 am
Re: FTL-2011 problem programming
To change com port go to
File
Configure
Com Port
Select correct com port for computer.
File
Configure
Com Port
Select correct com port for computer.
Re: vertex standard programming problem
i have a vertex standard vx-2500v and it keeps saying hardware mismatch how do i fix this ???