Page 1 of 1
ignition sense wiring help TK-790
Posted: Fri Aug 11, 2006 11:57 am
by stangmansvo
Hi all
Im looking for help to setup a TK-790 remote head radio to ignition sense.
thanks
steve
Posted: Fri Aug 11, 2006 10:52 pm
by Meatball
The ignition sense lead goes into pin 1 of the head accessory connector. Fuse for 3A.
Remove R504 and move it to the blank pads for R506. This is a surface mount component and care must be taken (I use a small pair of low-wattage soldering irons).
R504 is located on the right side of the top PC board.