The Radio Information Board

Just received my full alpha remote head TK-730G a few days ago and had a few questions regarding using the speaker off the remote head instead of the radio.

1. To use the speaker outputs on back of the head, first are pins 5 & 6 correct?

2. What do I have to do on the radio 15 pin connector to make the above work? (Jump 9 to 12?)

3. Another other changes, internal head or radio jumpers to remove?

4. On the 6 pin head Molex, which pins are 5 & 6 (Looking at the back of the head, upper right most pins?)

Thanks in advance,
Whit

Hello Whit,
1, yes
2, yes
3, none
4, The back side of the male molex is numbered.

Good luck and let us know if you need any help.

Well I have done all those to no avail. The only catch is that my 6 pin molex connector is not labeled like the 15 pin on the back of the radio, so I am guessing which pins are 5 & 6. I think I read looking at the back of the head, upper right most pins are 5 & 6. Looks like it is time to open up the KCH-4 and do some tracing.

Thanks,
Whit

I can send you a picture of mine. I'm guessing you don't have the numbers on the plug. I'll take a look at it tonight.

Looking at the connector.
____
/ 4 1 |
| 5 2 |
| 6 3 |
\____|

Well, sorta like that.

Great! Thanks as all is working as intended!

Whit