I have a link setup for a repeater using (2) Icom F121 VHF units and I use a PL/CTCSS tone to keep it clear. I am experiencing what seems to be audio chop-out on voice peaks ONLY when the PL tone is on. I am not detecting any over-deviation, tx freq is dead on, and I have adjusted the PL tone level up and down (DTCS/CTCSS deviation setting in CS-F100 software) and experienced no change. When I turn off the PL tone, the audio does not chop out. If I reduce the transmitter audio to a lower level, it does not chop out - but then the audio is too low.
I have purchased an extra F121 and swapped out the transmitter side of the system and there was no change in the symptom.
Thanks! Rick N3HIA
Forum dedicated to discussion on Icom Commercial Radio products such as F70, F80, F1721, F2821, F9011, F9021, F9411, F9521, F9511HT.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests