The Radio Information Board

Hello,
Question for the experts here:
I have an old VHF 5300 I would like to reprogram for CAP conventional system. On startup, it very briefly displays "EFJ * V200" , then shown a programmed channel. PCC 1.28.0.8 will read the version info and upload the radios current parameters, but only at Baud Rate 9600. Version info shows:

File Format Version 5.5
DSP Software versi0on 5.28
HC08 Software Version 11.11
Hardware Version Not Applicable
Radio Serial Number Not Applicable
Boot Load Version Not Applicable
SEM Version Not Applicable

I am not sure if PCC 1.20.0.8 is file format compatible even though it reads the parameters so I have not tried to download new parameters. What version of PCC and what are my options? Can the firmware be updated to be compatible with PCC 1.28?

Thanks

Bob
W0EG

Disregard. These early version 1 radios program with PCC 1.28.0.8, but only at 9600 baud and with the send/receive delay increased (I set ti to 15). The send/receive delay is found under the TOOLS menu.