Does anyone have any information on the process of programming the LPE-200?
~ How do you put the LPE-200 into the program Mode?
~ After its in the program mode does it display anything?
The process that I have been using is
1- radio off
2- press the PTT and the two buttons above it at the same time
3- turn the radio on
4- hook up the cables
5- place in charging cradle (for 12V power)
6- Start the EDACS programmer software
puting the LPE-200 into program mode
-
- Posts: 5
- Joined: Sat Feb 14, 2004 11:03 am
- Location: Great State of New Jersey
-
- Posts: 46
- Joined: Mon Feb 03, 2003 12:46 pm
LPE 200 Program mode
Your listing was a little confusing.
1) Press Ptt and both side buttons simulanteously
2) Turn on power
3) display shows no characters - all LCD segments are turned on for a window-screen appearance
4) connect programming cable and program
1) Press Ptt and both side buttons simulanteously
2) Turn on power
3) display shows no characters - all LCD segments are turned on for a window-screen appearance
4) connect programming cable and program